v4.8

1. Reorganization of program code. Adding service identification flags.
2. Combining code with "BLE_THSensor".
3. Correction of errors in transmission of the reed switch state when connecting.
4. Option added: One MY18B20 on PD2 TS0201S1, ZTH01S1; Two MY18B20 on PD2 and PD4 TS0201S2, ZTH01S2. Temperature from MY18B20 is transmitted in BTHome format.

v4.7

Changing sensor settings: Added slope factor, zero offset in 0.01 units.

v4.6

1. All thermometers support EXT OTA (fw size > 128 кB).
2. Flashing third party Zigbee OTA files (*.zigbee).

v4.5

1. Replacing BTHome ver1 (HA_BLE) with BTHome ver2.
2. Moving firmware after recovery to BLE from Zigbee OTA.
3. Fixed a bug where the date was not displayed correctly for MJWSD05MMC.
4. Added Zigbee OTA firmware files for recovery to BLE

v4.4

1. Adding an #380 (comment).
2. Only the value from the "EEP BindKey" #372.

v4.3

1. Increasing the degree of averaging (x64) of the sent values over the battery.
2. Added "Screen Off" option.
3. Check LYWSD03MMC HW: B1.5.
4. Added MHO-C122 (2AWMOMHOC122) test support.
5. LCD display stabilization LYWSD03MMC HW:B1.9

v4.2

1. Option Increasing Communication Distance: Bluetooth 5.0 LE Long Range (Advertising Extensions: primary and secondary Coded PHY S=8, Connectable).
2. Added support MHO-C401 (2022.11) and MJWSD05MMC.
3. Added function key: "Connect"
4. Averaging of sent values by battery.

v4.1

1. Improved stability in connected mode. I2C bus CLK and PullUp correction.
2. Changed "connection latency" for stability in connected.

v3.9

1. Changed the calculation of battery readings in %
2. Optimization of consumption for the solar battery when the voltage drops below 2V (deep-sleep)
3. Added option to invert event for reed switch
4. Small optimizations.

v3.8

1. Fix clear_memo
2. Renaming 'HA BLE' format to 'BTHome'