Firmware for durin.

uses platformio to build and upload. It's probably a bad practice but you can download it with pip. otherwise see their documentation All durins will configure mDNS so using durin[id].local as the IP should work

set wifi config

Durin can connect to two networks, One is hard coded to SSID: peopleNCS password: NCSpeople and the other is dynamic. To set the dynamic one use

python durin_configurator/main.py [DURIN IP] --wifi [ssid] [password]

set node id

sets the node id. used for mDNS and beacon

python durin_configurator/main.py [DURIN IP] -id [id]

runtime firmware update and build (recommended)

Durin will power off when it is done. you MUST power it on to verify the update

pio run && python durin_configurator/main.py [DURIN IP] --firmware .pio/build/esp32dev/firmware.bin --verify

normal platformio bootloader build and upload

enter bootloader mode and run this to build and upload (might have to change the upload_port in platformio.ini).

pio run -t upload -e esp32dev

only build

pio run

binaries will be put in .pio/build/esp32dev/

bootloader firmware update

run this while in the .pio/build/esp32/dev directory.

esptool.py --chip esp32 --port /dev/ttySS0 --baud 460800 --before default_reset --after hard_reset write_flash -z --flash_mode dio --flash_freq 40m --flash_size detect 0x1000 bootloader.bin 0x8000 partitions.bin 0x10000 firmware.bin