Screw used the wire cover on the A Drive is too short.

[marcellomaia]

The recommended screw to attache the wire cover on the A Drive is too small. Maybe a M3x10 instead of a M3x8 SHCS would be the right choice (page 261 of the manual).

[nemgrea]

8mm screws seem to be of adequate length...

if your foam tape is thicker than 1mm that may be your issue?

[marcellomaia]

I believe you did not understand the part I'm referring to. I'm talking about the screw marked below, the one the secures the wire cover on the A drive. The distance between the base of the screw to the top of the A drive is 7mm, so an 8mm screw I believe is not appropriate.

[nemgrea]

page 225 it looks like then

[atoomnetmarc]

Current revision has the error on page 231. M3x8 did not fit, M3x12 did fit.