7. Complete the ZTower

Now that the x gantry is installed the rest of the frame can be completed.

Attach the final 380mm crossbeam horizontally to the 355mm tower parts. On the front side attach using 12mm M5 screws into the Tower Corner Bracket Large then the plate bracket. Also attach a 30x30 corner bracket and secure it with 12mm M5 screws.

On the backside (where the rods are) use the Z Axis Rod Top Left Bracket and Z Axis Rod Top Right Bracket parts. Each of these requires a heat-sert into the space near the smooth rod hole.

mount each of these with 12mm M5 screws while also securing the smooth rod.

Use a 16mm 3M screw into opposite side from the heat-sert hole to secure the threaded rod.

The printer should now look similar to this.

Next complete the Y axis