-
Notifications
You must be signed in to change notification settings - Fork 3
HomeKit Setup
You must configure wifi network before adding the accessory to HomeKit. To configure Wi-Fi settings, device generates its own Wi-Fi in AP mode. You must connect to it in order to setup your Wi-Fi network.
Simply take your iOS device, go to Setting -> Wi-Fi, and search for an SSID called HomeKid-
followed by the module's MAC address and connect to it. For security reasons the AP is password protected!
Wait a few seconds until a web appears showing you all Wi-Fi networks that the device has found. Select yours, and enter password, then click the Join button! The module will try to connect the selected Wi-Fi network, this will take a couple of seconds.
Note: If the given password is wrong, you can Reset the Wi-fi settings by holding the Reset button for 10sec
In your iOS device, open Home App and follow normal steps to add a new accessory.
Pairing setup takes about 30 seconds.
Default HomeKit code is
Until the first release the default HomeKit code is 249-33-605
111-11-111
Also You can scan this HomeKit QR code:
Note: If pairing fails, you can unpower your device, repower it, and start HomeKit setup again (Wifi settings keep configured). After successful pairing the LED strip will flashing white 3 times!
The original Eve Light strip supports these two characteristics. With Transitions you can change the speed of the LED strip when fading to other color or turning on/off! Setting it to Quick
will disable fading in/out and it will quickly turn on!
With Power Behaviour you can change default color when the LED strip turn on! By default it is set to Last Used Color
, so when you turn off the LED strip it will always remember the last color you used! When set to Default White
, each time you turn off the LED strip, color will go back to White!
Note: This feature is still in beta! It may not work properly!
The code has a Reset function in case of something goes wrong. Wait about 5 seconds to allow device to boot completely, and then long press the button for at least 10sec!
Note: Single pressing the same button will toggle the LED strip ON or OFF
All configured settings has been removed and device is restarting. This removes HomeKit and Wi-Fi settings, and your device will go to Access Point mode next time in order to reconfigure Wi-Fi.
If wifi network becomes unreachable, device will keep searching Wi-Fi automatically until it can connect again when Wi-Fi becomes available.
If your ESP8266 module doesn't have physical button attached, you can use jumper wires to connect GPIO0 and GND for 10 seconds.
Note: Resetting the accessory may not remove it from the Home app, you need to do it manually after resetting! Before resetting the LED strip will flashing red 3 times, which indicates the start of Reset process!